vintage amplifiers

How to Install an Amp Kit? Amplifier wiring is a difficult task. With wiring kits this work can be done much easier. Still some work has to be done for attaching everything and you can go wrong. This wiring kit costs lower than the cost of the individuals.

The first thing to do before starting is the disconnection of the battery of the car. First the negative then the positive terminal is removed. If there is any hole in the heat shield coating in the car then use it. Or else make a small hole that is big enough to fit the power wire and heat protective wire cover.

The things needed to do this job are wire stripper, soldering gun , drill which is optional, a wrench that is adjustable and a screw driver. Keep these things ready before starting the work . Let us look at the steps in detail.

The end of the power wire is hold nearest to the fuse holder which is under the hood. The other end of the power wire is fed into the hole drilled in the heat shield. The wire is fed continuously along the side of the car till the rear seats are reached. The wire is further fed under the rear seats through the small gaps till it reaches the trunk. From the trunk the wire is taken to the positive terminal of the amplifier. End of the wire is stripped and it is connected to the positive terminal of the amplifier.

The next step would be to use screw drivers to loosen the tight fitting of the panels on the doors of the car. This should be done in two sides of the car where there are door frames. The power wire has two ends. One end is connected with the hole and the other to the holder of the fuse. The power wire is run continuously until paneling is found and reached. It can even be made to pass under the carpets. After trunk of the car is reached the power wire is connected with the positive terminal of amps. While doing this ensure the connection is tight and firm. Make it tighter using screw driver when connection is made after stripping of end of the power wire

Small remote wire is connected to the remote output at the back of the receiver which is blue in color. Twist them together to connect each other and use electric tape for safety. The wire is run alongside and connected between the negative and positive terminals. The speaker wires are connected to the speakers and the amplifier. One end of the speaker wire is connected to the amplifier's positive speaker wire. The other end is connected to the speaker's positive terminal. Panelling screws are tightened provided the wires running underneath are not damaged.

Now the speakers are connected to the amplifier through wires and the wires are connected in the amplifier based on the terminals. Later all the screws are tightened for a secure system. The fuse is removed from its place and the power wires are connected. After this the fuse is replaced back in its position.

Thus, this article explains How to Install an Amp Kit without much difficulty.

vintage amplifiers

vintage power amplifiers

Learn more about Auto. Stop by Author Name's site where you can find out all about Car stereo and what it can do for you.

vintage amplifiers: vintage power amplifiers

This article, the best article ever, kindly provided by UberArticles.com